Cirrus-logic CS5368 Manuel d'utilisateur télécharger pdf (Page 30)

30 DS624F5

CS5368

4.13 Control Port Operation

The Control Port is used to read and write the internal device registers. It supports two industry standard

formats, I²C and SPI. The part is in I²C format by default. SPI Mode is selected if there is ever a high-to-low

transition on the AD0/CS

pin after the RST pin has been restored high.

In Control Port Mode, all features of the CS5368 are available. Four multi-use configuration pins become

software pins that support the I²C or SPI bus protocol. To initiate Control Port Mode, a controller that sup-

ports I²C or SPI must be used to enable the internal register functionality. This is done by setting the

CP-EN bit (Bit 7 of the Global Control Port Register). Once CP-EN is set, all of the device configuration pins

are ignored, and the internal register settings determine the operating modes of the part.

4.13.1 SPI Mode

In SPI Mode, CS is the CS5368 chip select signal; CCLK is the control port bit clock (input into the CS5368

from a controller); CDIN is the input data line from a controller; CDOUT is the output data line to a controller.

Data is clocked in on the rising edge of CCLK and is supplied on the falling edge of CCLK.

To write to a register, bring CS low. The first seven bits on CDIN form the chip address and must be

1001111. The eighth bit is a read/write indicator (R/W), which should be low to write. The next eight bits

form the Memory Address Pointer (MAP), which is set to the address of the register that is to be updated.

The next eight bits are the data that will be placed into the register designated by the MAP. During writes,

the CDOUT output stays in the Hi-Z state. It may be externally pulled high or low with a 47 k resistor, if

desired.

There is a MAP auto-increment capability, which is enabled by the INCR bit in the MAP register. If INCR is

a zero, the MAP will stay constant for successive read or writes. If INCR is set to a 1, the MAP will auto-

increment after each byte is read or written, allowing block reads or writes of successive registers.

To read a register, the MAP has to be set to the correct address by executing a partial write cycle that fin-

ishes (CS

high) immediately after the MAP byte. The MAP auto-increment bit (INCR) may be set or not, as

desired. To begin a read, bring CS

low, send out the chip address and set the read/write bit (R/W) high.

The next falling edge of CCLK will clock out the MSB of the addressed register (CDOUT will leave the high

impedance state). If the MAP auto-increment bit is set to 1, the data for successive registers will appear

consecutively

Figure 16. SPI Format

MAP

MSB

LSB

DATA

byte 1

byte n

R/W

ADDRESS

CHIP

ADDRESS

CHIP

CDIN

CCLK

CDOUT

MSB

LSB

MSB

LSB

1001111

MAP = Memory Address Pointer, 8 bits, MSB first

High Impedance

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

Commentaires sur ces manuels

Pas de commentaire

Cirrus-logic CS5368 Manuel d'utilisateur Page 30

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Cirrus-logic CS5368